Page 1 of 1

Shore Power Alert problem

Posted: Tue Apr 09, 2019 2:26 pm
by sq5npw

Currently, in my test SM environment, I have two voltage sensors, THD sensor and shore power sensor.

I noticed that after calling the ShorePower Alert, the entire sm_remoteunit table often disappears in the SQLite database on the ramdisk.
Then ShorePower Alerts no longer work.
After the RPI reboot, the SQLite database is recreated and the sm_remoteunit table reappears.

At the moment, the content of this table has disappeared.

Best Regards,
(It can be anyway, if you prefer)

Re: Shore Power Alert problem

Posted: Wed Apr 10, 2019 12:55 pm
by crb
Hi Jerzy/Jurek :D

I don't have a shore power alert rigged up at the moment. I'll try to set one up and see if I can emulate the problem.


Re: Shore Power Alert problem

Posted: Tue Apr 16, 2019 11:29 am
by crb
Hi Jerzy,

I've set up shore power and m not able to reproduce your problem. Is it just one table or the whole database which disappears? Does it happen every time there is a shore power alert, or is it intermittent?